Publicité
Les langues disponibles
Les langues disponibles
Protect the machine from rain and moisture.
Always hold the saw with two hands when the
engine is running.
Use the claw to position the saw for every cut and
always start every cut with the chain moving.
Complete the cut in such a way that the saw does
not become trapped in the wood.
Pay special attention to branches that are under
tension.
Only pull the machine out of the wood whilst the
chain is still moving.
Never saw using one hand over shoulder height.
Always stand perpendicular to the slope when
using the saw on a gradient.
Always stand to the side of falling trees.
Watch the falling direction of the sawn parts.
Never start a cut using the tip of the bar and never saw
using the tip of the bar – danger of recoil!
There is always a risk of recoil if the tip of the bar
touches wood or other objects. This makes the
chainsaw impossible to control and may lead to
it being catapulted with great force towards the
operator.
Always saw through one branch at a time.
Watch neighbouring branches when lopping
branches off a tree.
Never use the machine as a lever for moving
objects.
Always use the chain guard for transporting the
chainsaw.
Before use
Check the machine and chain to ensure that they
are in perfect working order and safe to use.
Check the function of the chain lubrication system and
the oil level. Check the chain tension and the function of
the chain brake.
Machine components (B1-B2)
1. Guide bar
2. Saw chain
3. Chain guard
4. Chain brake / Hand guard
5. Claw stop
6. Sprocket wheel cover
7. Guide bar bolts/screws
8. Chain adjustment screw
9. Front handle
10. Rear handle
11. Starter cable
12. Oil tank cover
13. Petrol tank cover
14. Safety trip
15. Spark plug wrench
16. Air filter cover
17. Choke lever
18. Control switch
19. Throttle lever
20. Oil discharge duct
21. Fuel mixing canister
22. Screwdriver
23. Primer button
Assembly (B3-B4)
The saw chain and chain guide bar are not supplied
ready-assembled.
To prevent injuries, wear gloves when fitting the
saw chain, when tensioning the chain and during
the subsequent chain tension check.
Fit the guide bar
- First disconnect the chain brake. Press the hand
guard (4) towards the top handle for this purpose.
- Remove the sprocket wheel cover (6) by undoing the
two guide bar screws (7).
- Assemble the claw stop (5) according to the picture
above by using the spark plug wrench.(B31)
- Place the guide bar (1) with the notched end on
the two guide bar bolts (7).
11
G
B
Publicité
