19. Or rinse (from the inside of the cartridge filter 14 ) with
water. Fig. 11. Dry completely (approximately 24 hours).
Fig. 11
INSTALLING FILTER BAG
Use the filter bag 17 in conjunction with the cartridge filter 14
for easy disposal of the debris. The filter bag 17 is not required
for normal dry pick up. When picking up fine dust or powders
a high efficiency filter bag (not standard with all models)
must be used. NOTE: For dry use only.
WARNING:
IS DISCONNECTED FROM THE RECEPTACLE,
TANK COVER IS REMOVED AND THE HOSE IS
DISCONNECTED FROM TANK INLET.
20. Remove inlet deflector from deflector guide. NOTE: Hose
12 must be removed before inlet deflector can be taken
out. Fig. 12.
Fig. 12
21. With the opening of the inlet deflector facing the left or
right side of the filter bag 17 , slide filter bag collar 17
over deflector matching notches of bag collar to tabs on
inlet deflector. Bag will only fit properly one way. Fig. 13.
Fig. 13
17
:
MAKE SURE THE CORD
22. Slide deflector with filter bag 17 attached into deflector
guide. Fig. 14.
Fig. 14
23. Reinsert hose 12 into inlet and tighten locking-nut.
When secured in place expand bag 17 and position
around inside of tank.
24. NOTE: When removing filter bag 17 from tank, remove
inlet deflector from filter bag collar and reinstall into
deflector guide. Inlet deflector should always be in place
for any type of cleaning.
WARNING:
EFFICIENCY OF THE VACUUM IS LARGELY
DEPENDENT ON THE FILTER. A CLOGGED FILTER
CAN CAUSE OVERHEATING AND POSSIBLY
DAMAGE THE CLEANER. CHECK THE FILTER
PERIODICALLY AND REPLACE AS REQUIRED.
WARNING:
POWDERS
When vacuuming fine dust, or powders of any kind
(plaster, drywall dust, cold ashes, concrete dust, etc.)
a high efficiency drywall filter bag must be used.
When vacuuming normal household dust and debris,
standard household disposable filter bags may be
used.
25. Check the filter bag 17 for tears or small holes. If none
are found, reinstall the filter bag 17 . To prevent damage
to this vacuum, do not use a filter bag 17 with a hole or
a tear.
WET PICK UP OPERATION
26. Your vacuum can be used for wet pick up. Remove ALL
dirt and debris found in the tank. Remove all dry use only
filters, including the filter bag 17 , from this vacuum.
27. A clean cartridge filter 14 may be used to pick up small
quantities of liquid. To use the cartridge filter 14 ; follow
the cleaning and installation instructions under dry pick
up.
28. For vacuuming large quantities of liquid use a foam
sleeve 16 . To use the foam sleeve 16 ; follow the
installation instructions in this section.
ENGLISH
KEEP FILTERS CLEAN.
FOR FINE DUST
6