Makita EY2650H Manuel D'emploi Et De Sécurité page 12

Adjusting the chain-oil feeding rate
The chain-oil feeding rate is adjustable in three steps. According to the
operation, for example cutting hard limbs, adjust the feeding rate.
To adjust the chain-oil feeding rate, use a flat-bladed screwdriver. Push in the
adjusting screw and turn it. To increase feeding rate, turn the adjusting screw
counterclockwise (A). To reduce feeding rate, turn it clockwise (B).
After adjusting the chain-oil feeding rate, check the feeding rate by driving the
equipment at medium speed.
Adjusting the length of pole saw
Adjust the length of the pole saw as follows:
1. Turn the knob (A) counterclockwise.
2. Adjust the length of the pole.
3. Turn the knob clockwise to fasten the gear head.
Shoulder strap
Adjusting the shoulder strap
Adjust the strap to the suitable length for your operation.
Detachment
In case of emergency, push the notches (A) at both sides, and detach the
equipment.
Be extremely careful to maintain control of the equipment at this time. Do not
allow the equipment to be deflected toward you or anyone in your vicinity.
WARNING: Failure to maintain complete control of the machine at all could
result in serious injury or DEATH.
Note: In some countries, shoulder strap does not have this detachment function.
Hanger
12
A B
A
A