Bimar VT366.NE Notice D'instructions page 9

 Ensure that the fan is switched off from the supply mains before
removing the guard.
INSTALLATION
 After removing the packing materials, check the integrity of the heater; if you are
unsure, do not use it and ask for qualified professional help. The packing
materials (plastic bags, polystyrene foam, nails, etc.) must be kept out the reach
of children because they are potential sources of danger. Attention: any stickers
or advertising material applied to the grid removed before using the appliance.
The manufacturer declines all responsibility in case this is not safe working
practices will be respected.
 Before connecting the appliance, check that the voltage values shown on the data
plate correspond to those of the electricity supply network. In the event of
incompatibility between the electric outlet and the plug of the appliance, have the
outlet replaced with another more suitable type by professionally qualified
personnel, who will make sure that the section of the wires of the outlet is
appropriate for the absorbed power of the appliance. In general, the use of
adapters or extension cords is not recommended; if their use is indispensable,
they must conform to existing safety standards and their current capacity
(amperes) must not be less that the maximum of the heater.
 The power socket must be easy to reach so the plug can be removed quickly in
case of emergency.
 Do not place the fan on a shelf and/or near sinks or other container of liquids
(minimum distance of 2 meters) to avoid the risk of it falling in.
 Keep the fan far away from fabrics (curtains, etc.) or unstable materials that
could obstruct the air intake grille; make sure that the front is free of unstable
materials (dust, etc.).
 Make sure that the electric cord is not touching rough, hot or moving surfaces
and not twisted or wrapped around the appliance.
 Stand the appliance on a horizontal, flat surface or table; do not stand on a
inclined plane (the appliance could upset).
 Do not place the appliance near an open flame, cooking or other heating
appliance.
 In the event of a breakdown or poor operation, turn the fan heater off and ask for
professionally qualified help.
ASSEMBLY
Before each use, verify that the unit is in good condition, the electric cord is not
damaged, if the power cord is damaged, it must be replaced by the manufacturer
or a competent qualified electrician or a person with similar qualifications, in order
to avoid any risk.
Attention: the fan can be used only when completely and correctly assembled,
that is complete with its base and protection grid.
Attention: always unplug the appliance before you assemble.
If in doubt, have the appliance checked or assembled by a qualified professional
person. For assembly, refer to figure.
9/32