Bimar VT366.NE Notice D'instructions page 10

1. Insert the lower part of the body in the base (8) (see the
figure to the right), make sure that the 3 hooks come out
of their relative slots.
Attention: without the base the fan can not be used.
2. Fasten the rear grid (4) to the motor casing, verify that
the handle appears in the back (as shown) and
using the appropriate ring nut (3).
3. Insert the fan (10) on the motor shaft (5) and lock with
the appropriate ring nut (12) turning it tightly anti-
clockwise.
4. Couple the front grid (1) to the rear grid (4), blocking with
the ring perimeter plastic; and secure it with the screw
with nut, (11) must be in the lower part. Having done this,
check that the protection grid is firmly coupled and
fastened to the motor.
USE
Before each use, verify that the unit is in good condition, the electric cord is not
damaged, if the power cord is damaged, it must be replaced by the manufacturer
or a competent qualified electrician or a person with similar qualifications, in order
to avoid any risk.
Insert the plug of the fan in the power supply.
Ventilation: select the desired speed with the selector (9).
1 – Minimum speed 2 – Medium Speed 3-Maximum speed
To turn the fan off, press the "0" key and then remove the plug from the socket.
Horizontal oscillation (right-left): this is selected with the button (6) located on
the motor body. To stop the motion and keep the ventilator still, press the button.
Vertical inclination (high-low): it is regulated by gripping the motor body and
orienting it in the direction desired; you will hear "click" that indicate the fan's
various position.
When not in use for long periods, the plug must always be removed from
the socket.
1) Front grille
2) Ring perimeter plastic
3) Grille attachment ring
4) Rear grille
5) Motor shaft
6) Oscillation button
7) Body
8) Base
9) Selector
10) Fan
11) Screws and nuts for
12) Fan attachment ring
lock
10/32
nut
fasten the grilles
nut