dji C8000 Guide D'utilisateur page 6

Les langues disponibles

Activation

The battery station requires activation before using for the first time. If the warning indicator

is solid green, it means the battery station has not been activated. Follow the steps below to

activate the battery station:

Method 1: Using the App

1. Connect the battery station to a power outlet.

2. Connect the battery station to the USB-A port on the remote controller using a USB-C cable.

3. Press the power button to power on the battery station.

4. Run the app compatible with the aircraft and follow the prompts to finish activation.

Method 2: Using DJI Assistant 2 (MG Series) / (Delivery Drones Series)

1. Connect the battery station to a power outlet.

2. Connect the battery station to the computer using a USB-C cable.

3. Visit www.dji.com to download DJI Assistant 2 (MG Series) / (Delivery Drones Series). Install

and run the software.

4. Press the power button to power on the battery station.

5. Use your DJI account to log in and click the corresponding charging device and follow the

prompts to finish activation.

Make sure the computer or remote controller is connected to the internet during activation.

Internet

Using the Battery Station

Up to two batteries can be connected to the battery station. Follow the instructions below to

use the battery station.

1. Connect the battery station to a power outlet.

Each AC power cable must be connected to a separate AC power outlet or power strip

with a rated current of more than 16 A.

Only use one AC power cable when using the battery station indoors. This will reduce

the maximum power output by half.

Users can set the max charging power limit in DJI Assistant 2 according to their

requirements to avoid safety risks such as short circuits due to excessive power.

> 16 A