Panasonic ES7056 Manuel D'utilisation page 9

Cleaning with the self-cleaning recharger (continued)
Do the following if the status lamp blinks or glows during the
"Clean/Dry/Charge" course or the "Clean/Dry" course.
Blinks Glows
Correctly set the Remove the shaver from the self-cleaning
detergent cartridge recharger and then check that the [clean]
and then restart a lamp has gone out. (Be careful as the
course. blade may be hot or wet.) Check that the
water tank is correctly attached, the water
tank cap is securely closed and the self-
If the status lamp
cleaning recharger is placed horizontally.
goes out
Continue a course.
When an abnormality has
been corrected
Press and hold [select] for
approximately 2 seconds to
turn off the status lamp and
then restart a course.
When the status lamp goes
out
Continue a course.
When no abnormality was
found
It is time to replace the
detergent cartridge and
cleaning liquid inside the water
tank.
Drain the old cleaning liquid
inside the water tank and then
refill it with water. Replace the
old detergent cartridge and
then restart the course.
When the status lamp glows
again
Contact an authorized service
center.
Cleaning the shaver without the self-cleaning
recharger
1. Apply some hand soap to the
outer foil.
2. Turn the shaver on and then
pour some water over the
outer foil.
3. Turn the shaver off after 10-20
seconds.
4. Remove the foil frame and
clean it with running water.
5. Wipe off any drops of water
with a dry cloth.
6. Remove the protective cap to
allow the system outer foil to
dry completely.
9