Aiphone JK-1MD Manuel D'installation Et D'utilisation page 9

6-6 Pan/Tilt operation
1
When a zoom picture is displayed, press the ［ ］ ［ ］ ［ ］ and ［ ］
buttons.
• ［ ］: Up
• ［ ］: Down
• ［ ］: Left
• ［ ］: Right
• Moving diagonally is also possible.
6-7 Zoom Picture Preset
The picture can be set to display using a set zoom picture position for
when a call is received from the door station. When switching from the
wide picture to the zoom picture, the zoom picture displays at the pre-set
position.
1
When a zoom picture is displayed, press the ［ ］ ［ ］ ［ ］ and ［ ］
buttons.
• While viewing the picture, set the desired picture position.
NOTES: 1. To change the zoom picture position that has been set, perform
the zoom position setting again. The previous setting will be
overwritten.
2. The zoom picture position set with the monitor station will be
reflected with the sub monitor station. ※ Pre-setting cannot be done
from the sub monitor station (JK-1HD).
6-8 Night illumination
At night, the door station Illuminator LED lights up during
calling or communication.
6-8-1
When a call is made from the doorstation
1
If CALL button of door station is pressed
2
When communication ends, the illuminator LED will go out.
The Illuminator
LED lights up.
- 9 -
[Zoom picture]
The image range of the zoom picture and wide picture differs. The
edges of the wide picture do not display with the zoom picture.
2
ZOOM/WIDE button (for ２ seconds to more).
Press
• A beep will sound and the position setting will be completed.
6-8-2
When the Illuminator LED is lit up during entrance
monitoring
1
When TALK button is pressed during
entrance monitoring, communication starts
and the Illuminator LED will light up.
• Inside sound can be heard at the entrance.
Communication starts at this time,
so be aware that inside sound can
be heard at the entrance.
2
When communication ends, the illuminator LED will go out.
NOTES: Distinguishing between day and night is automatically done by the door
station.