Kinderkraft FINIX Guide D'utilisation page 22

8. Bolts (for affixing the front top legs) x 2
2. Assembly of the high chair
Screw the front upper legs with plastic elements for fixing the footrest (2) into holes located in
the front of the seat (1) (Figures A and B). Make sure that plastic elements are on inside parts
of legs. Next, turn the seat with the legs screwed in. Screw the bolts (8) to the legs in the
openings in the correct part of the seat (figure C). Select the position of the footrest (6) in
accordance with the size of your child. The variant presented in Figure D1 is dedicated to smaller
children. The variant in Figure D2 is dedicated to larger children. Slide the footrest (6) into plastic
elements on inside parts of legs (Figure E). You will hear a characteristic click sound. Then screw
the rear upper legs (3) into holes located on the back of the seat (1) (Figures F and G). Tighten
the front and rear lower legs (4) (Figure H). Adjust white feet located at the end of lower legs in
order to ensure that the entire oblique plane adheres to the floor (Figure I).
2.2 Fixing and adjusting the tray
In order to mount the tray (5), slide it into the guides while pressing the button on the front of
the tray (Figure J). To adjust the tray, press the button and select one of three settings (Figure J).
The tray has a plastic removable insert (Figure K).
2.3 Use of adjustable safety belts
Adjustment:
The adjustment is made with the assistance of plastic elements located on belts. By moving the
element up or down the belt, you can increase or decrease the length of belts – they can be
conveniently adjusted to the child's size. All belts are connected with a buckle (Figure L).
Dismantling of belts:
In order to disassemble the belts, press a convex fragment of the plastic joint and pull the belts
individually from the rim (Figures M and N). Then pull the already disconnected belts trough
holes in the chair (Figures O and P).
Assembly of belts:
NOTE! Figures L -P show the disassembly of the belts. In the case of reassembly, follow the
arrow and drawings in a reverse order.
Pull the disconnected belts through the holes of the chair (Figures O and P). In order to install
the belts, press the convex part of the plastic joint and then press the belts individually into the
rim (Figures M and N).
2.4 Adjustment of the footrest
In order to change the position of the footrest (6), simultaneously press buttons on plastic
elements located on both legs (Figure R) and pull out the footrest (6). Turn the footrest (6) upside
down and then insert it back into plastic pieces on inside parts of legs (Figure E).
The footrest should always be installed when the chair is in the high leg configuration. It should
be removed when you convert the product into a chair for older children.
22