Buffalo CJ306 Mode D'emploi page 3

• BUFFALO recommend that this appliance should be periodically
tested (at least annually) by a Competent Person. Testing
should include, but not be limited to: Visual Inspection,
Polarity Test, Earth Continuity, Insulation Continuity and
Functional Testing.
• BUFFALO recommend that this product is connected to a
circuit protected by an appropriate RCD (Residual Current
Device).
• Only use the appliance with the detachable power cord as
provided.
Introduction
Please take a few moments to carefully read through this manual. Correct maintenance and operation of
this machine will provide the best possible performance from your BUFFALO product.
Pack Contents
The following is included:
• BUFFALO Knife Steriliser
• Instruction manual
BUFFALO prides itself on quality and service, ensuring that at the time of unpacking the contents are
supplied fully functional and free of damage.
Should you find any damage as a result of transit, please contact your BUFFALO dealer immediately.
Installation
• Ensure you have adequate support to support
the appliance and proceed to drill and install the
fixing screws.
• Once the screws are installed, locate the
appliance on the wall by aligning the locating
holes on the back plate with the screws.
Warning: Ensure the substrate and fixings
used to mount the Knife Steriliser are
suitable to support the weight of the loaded
unit.
If necessary, seek professional help to
ensure the shelf is safely mounted.
CJ306_ML_A5_v1_20230329.indb 3 CJ306_ML_A5_v1_20230329.indb 3
• Key
• Detachable power cord
• Mounting screws
300mm
EN
3
2023/3/29 14:37 2023/3/29 14:37