Functional Description; Product Features; Intended Use - Bosch PST 700 E Notice Originale

OBJ_BUCH-1067-001.book Page 17 Monday, September 28, 2009 8:35 AM
Secure the workpiece. A workpiece clamped
with clamping devices or in a vice is held
more secure than by hand.
Keep your workplace clean. Blends of mate-
rials are particularly dangerous. Dust from
light alloys can burn or explode.
Always wait until the machine has come to
a complete stop before placing it down. The
tool insert can jam and lead to loss of control
over the power tool.
Never use the machine with a damaged ca-
ble. Do not touch the damaged cable and
pull the mains plug when the cable is dam-
aged while working. Damaged cables in-
crease the risk of an electric shock.
Products sold in GB only: Your product is fit-
ted with an BS 1363/A approved electric
plug with internal fuse (ASTA approved to
BS 1362).
If the plug is not suitable for your socket out-
lets, it should be cut off and an appropriate
plug fitted in its place by an authorised cus-
tomer service agent. The replacement plug
should have the same fuse rating as the orig-
inal plug.
The severed plug must be disposed of to
avoid a possible shock hazard and should nev-
er be inserted into a mains socket elsewhere.
Products sold in AUS and NZ only: Use a re-
sidual current device (RCD) with a rated re-
sidual current of 30 mA or less.

Functional Description

Read all safety warnings and all in-
structions. Failure to follow the
warnings and instructions may re-
sult in electric shock, fire and/or se-
rious injury.

Intended Use

The machine is intended for making separating
cuts and cut-outs in wood, plastic, metal, ce-
ramic plates and rubber while resting firmly on
the workpiece. It is suitable for straight and
curved cuts with mitre angles to 45°. The saw
blade recommendations are to be observed.
Bosch Power Tools

Product Features

The numbering of the product features refers to
the illustration of the machine on the graphics
page.
1 Lock-off button for On/Off switch
2 On/Off switch
3 Vacuum hose*
4 Vacuum connection
5 Base plate
6 Switch for sawdust blowing device
7 Guide roller
8 Saw blade*
9 "Cut Control" viewing window*
10 "Cut Control" base*
11 Contact protector
12 Handle (insulated gripping surface)
13 Saw blade holder
14 Splinter guard*
15 Lead for the parallel guide
16 Holder for guide roller
17 Screw
18 Scale for mitre angle
19 Parallel guide with circle cutter*
20 Locking screw for parallel guide*
21 Centring tip of the parallel guide*
22 Cutting mark, 0°
23 Cutting mark, 45°
*Accessories shown or described are not part of the
standard delivery scope of the product. A complete
overview of accessories can be found in our acces-
sories program.
2 609 003 949 | (28.9.09)
English | 17