GYS AIRFIX DRAW ALIGNER Mode D'emploi page 14

Operating manual
INSTALLATION AND INSPECTION CHECKS
REGULAR INSPECTION:
- Check that the screws are correctly tightened as described in the «assembly» section.
- Check that the foam gasket and pads are correctly positioned and undamaged.
- Check that the cord is correctly wound on the winch, and that it is not damaged.
If in doubt and/or if a defect is found, do not use the machine and contact the distributor or the manufacturer via the
After Sales Service.
INSTALLATION:
To ensure maximum adhesion to the fl oor, it is essential to position the Airfi x Draw Aligner in a clean area (free of dust
liquids or other contaminants) with no cracks or joints between the tiles to ensure maximum vacuum performance.
The Airfi x Draw Aligner is fi tted with two rear wheels, tilt the column taking care not to damage the seal which is
located on the underside of the plate.
The Airfi x Draw Aligner works with compressed air, the recommended pressure is between 5 and 8 bar.
USAGE:
- Move the pillar by tilting it backwards to the chosen work area.
- Position the Airfi x Draw Aligner at an appropriate pulling distance, judged by the operator, as close as possible to the
point being repaired.
- Connect the compressed air hose. Check that the Airfi x Draw Aligner is fi rmly anchored to the ground by pushing it
fi rmly.
If the column does not stay in position, check the placement of the seal and the condition of the fl oor,
and repeat the previous operation.
Adjust the winch position to the desired working level. To do this:
- Raise the safety pin at the rear of the winch stand, and tilt the front of the mount upwards.
- Lower or raise the winch while keeping the safety pin raised and the bracket tilted to the desired working po-
sition. Please ensure that the notch is correctly located in the opening in the column.
14
Translation of the original
instructions
Attach the winch to the bracket using the reinforcement
plate and the 3 bolts. Use an H5 spanner.
Place the trolley with the winch on the column.
AIRFIX DRAW ALIGNER
Screw M6x18: 3
Nut M6: 3