GYS AIRFIX DRAW ALIGNER Mode D'emploi page 13

Operating manual
Translation of the original
instructions
ASSEMBLY
Screw the left and right brackets to the base of the co-
lumn using an H8 spanner.
Be careful to position the column with the
notches on the right side, see image.
Screw the column / brackets assembly to the plate using
an H8 spanner.
Screw the wheel supports to the plate using an H8
spanner.
Screw the wheels and their axles to the wheel brackets
using an H8 spanner.
Screw the pulley to the bracket using two 19mm span-
ners.
AIRFIX DRAW ALIGNER
Screw M10x25: 8
Safety washer M10: 8
Screw M10x18: 6
Safety washer M10: 6
Screw M10x18 : 2
Flat washer M10 : 2
Safety washer M10: 2
Screw M10x18: 4
Safety washer M10: 4
Screw M12x85: 1
Washer M12: 2
Nut M12: 1
13