Télécharger Imprimer la page

aqua HC797 Manuel page 16

Masquer les pouces Voir aussi pour HC797:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 21
3.0 MAINTENANCE
3.1 General maintenance comments
Regular maintenance is essential if the pump has to give good service over a
long period.
The following advice should be strictly followed:
It is difficult to estimate the periods between maintenance operations,
because of the pumps operating conditions and the chemicals employed. It is
therefore the basic responsibility of the operator to check regularly the
appearance and condition of the pump and to clean and service it according
to his findings
3.2 Periodic maintenance
Liquid's level in the tank should be monitored regularly and the tank refilled a
necessary to avoid the running dry of the pump. Wet parts of the pump, foot
valve, suction/delivery valves and the head and diaphragm should be
inspected and cleaned at least every 3 months. Where very aggressive
chemicals are being dosed, (Sodium Hypo chlorite is particularly difficult) this
period may need to be reduced and cleaning be carried out more frequently. If
pumps are not used for long periods, scale, sediment and encrustation
deposits can build up causing the pump to malfunction. We highly
recommend careful maintenance of the valves by running them under clean
water after long periods of non use. Alternatively, if the pump has not been
used for long periods, before re-setting up the operations, we strongly
recommend operating it for at least 30 minutes with the foot filter immersed in
clean water to flush the pump.
3.3 Basic maintenance procedures
Before doing any maintenance read with attention the technical and safety characteristic of the
dosing chemicals and follow the next procedures:
1 Turn off the pump and immerse the foot filter and the injection tube in clean water. Turn on the
pump to let the water go through the pump head. If there are some crystals to be cleaned follow the
next procedures:
2 Immerse the foot filter and the injection tube into an adequate solution to remove the crystals (ex.
Chloridric Acid for Sodium Hipochlorite crystals); let the pump work for some minute. Then repeat
the action with water and connect the pump to the plant.
ATTENTION!!!!!
It's necessary to effectuate all the operations with gloves and glasses
suitable for the product used then consult the supplier of the chemical
product.
28/05/13 Rev.2.6
All manuals and user guides at all-guides.com
16
ENGLISH

Publicité

loading

Ce manuel est également adapté pour:

Hc897Hc997