Doro PhoneEasy 312cs Mode D'emploi page 7

Use v / V to enable/disable the LED indicator for new calls,
and confirm with
Tone/pulse
TONE
is displayed.
Use v / V to select either tone or pulse dialling mode, and
confirm with
Note!
If you are unsure of which dialling mode to use, select TONE
as this works in most locations.
Basic setup of the telephone is now completed.
Wall mounting
The telephone can be wall mounted by using the included wall
mount bracket and two screws (not included).
Warning!
Make sure that no cables, water pipes or gas pipes are
located inside the wall before drilling into it.
1. Drill two holes in the wall, corresponding to the holes in the
wall mount bracket.
2. Insert the screws, allowing them to project ~5 mm out from
the wall.
3. Unplug and remove the handset.
4. Fit the guide tabs (A) on the bracket into the slots (B) on the
back of the telephone, then slide the bracket upwards until it
snaps into place.
All manuals and user guides at all-guides.com
.
.
English
4