Ryobi ONE+ PCL735 Manuel D'utilisation page 7

REMOVING WASTE FROM THE COLLECTION
CONTAINER
See Figure 8 - 9, pages 9 -10.
The collection container should be checked, emptied, and
cleaned periodically to obtain maximum efficiency.
Dry waste:
„ Remove the battery pack.
„ Unlock the locking latches and remove the lid.
„ Remove the dry use filter.
„ Inspect filter, lightly shake any dust or dirt from the filter,
or replace as necessary.
„ Empty the collection container; wash out if necessary.
„ Reinstall dry use filter.
„ Before replacing the lid, make sure all pieces are com-
pletely dry.
„ Replace lid and lock securely.
Liquid waste:
„ Remove the battery pack.
„ Unlock the locking latches and remove the lid.
„ Empty the collection container; wash out if necessary.
Before replacing the lid, make sure all pieces are com-
pletely dry.
„ Replace lid and lock securely.
CAUTION:
Do not allow liquid pick up to remain in the collection
container for extended periods of time. Moisture can
develop in the motor compartment and shorten the life
of the motor.
CAUTION:
Do not turn unit upside down, as liquid may enter the
motor unit.
AFTER FRENCH AND SPANISH LANGUAGE SECTIONS.
MAINTENANCE
NOTE: ILLUSTRATIONS START ON PAGE 8
CLEANING/REPLACING THE DRY USE FILTER
See Figure 10, page 10.
„ Remove the battery pack.
„ Unlock the locking latches and remove the lid.
To clean:
„ The filter has a cap that locks the filter to the filter cage.
Remove the filter by rotating the cap counterclockwise
to unlock and pull the cap off.
„ Remove the filter from the filter cage.
„ Lightly shake any dust or dirt off the filter.
„ Reinstall by sliding the filter over the filter cage and push-
ing down until flush with the lid. Align the cap and rotate
clockwise to lock into place.
NOTE: Make sure the filter is seated properly for dry
vacuuming. Remove the filter for wet vacuuming.
To replace:
„ Remove the filter by rotating the cap counterclockwise
to unlock and pull the cap off.
„ Remove the filter from the filter cage.
„ Replace with new filter by sliding new filter over filter cage
and pushing down until flush with the lid. Align filter cap
and turn clockwise to lock into place.
NOTE: Make sure the filter is seated properly.
When purchasing replacement filter, request recommended
part number 019166001025 (Model number A32RF06).
STORAGE
„ Clean all foreign material from the wet/dry vac.
„ Clean the outside of the collection container with warm
water and mild soap.
„ Empty and clean the collection container, flexible hose,
nozzles, and attachments with warm water and mild soap
and allow to completely dry before storage.
„ Store flexible hose and attachments inside the collection
container or on the lid.
„ The collection container should be disinfected as needed
and before prolonged storage.
„ Store indoors in a place that is inaccessible to children.
Keep away from corrosive agents such as garden chemi-
cals and de-icing salts.
7 — English