Ryobi ONE+ PCL735 Manuel D'utilisation page 6

INSTALLING/REMOVING ATTACHMENTS
See Figure 4, page 9.
Vacuuming can be performed with only the flexible hose or
the hose with vacuum attachments.
„ Turn off the wet/dry vac.
„ Insert the attachment onto the tapered end of the flexible
hose, making sure the attachment is firmly in place.
„ To remove, hold the attachment and pull from hose.
DRY VACUUMING
See Figure 5, page 9.
Vacuum only items small enough to fit through the hose or
the attachment. The performance of the wet/dry vac will
decrease with a full collection container. When emptying the
collection container, check to see if the filter needs cleaning.
CAUTION:
In low relative humidity conditions, vacuuming fine debris
with the wet/dry vac can cause a static charge resulting
in static shock. To reduce static shock while using, add
moisture to the air with a humidifier.
WET VACUUMING
See Figure 6, page 9.
When wet vacuuming, be aware that the wet/dry vac is
equipped with a water float inside the filter unit housing.
This water float is designed to shut off the suction when the
collection container reaches full wet capacity. When the col-
lection container is full, turn the wet/dry vac OFF and empty
the collection container as shown in Maintenance.
„ Unlock the locking latches and remove the lid.
WARNING:
When servicing, use only identical replacement parts.
Use of any other part could create a hazard or cause
product damage.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and can be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
OPERATION
„ Remove the dry use filter by rotating the filter counter-
clockwise to unlock and pull the filter free of the filter
housing.
„ Replace lid and lock securely.
WARNING:
When vacuuming liquid, make sure the canister vac or
battery does not get submerged or doused in liquid,
which could cause shock, vacuum failure, or personal
injury.
USING THE WET/DRY VAC AS A BLOWER
See Figure 7, page 9.
At all times, the wet/dry vac blows air through the blower
port as part of the exhaust system. However, you can use
the wet/dry vac as a blower by attaching the flexible hose
to the blower port.
„ Turn off the wet/dry vac and remove the battery pack.
„ Remove the hose from the tank.
„ Attach the the flexible hose to the blower port to use as
a blower.
To keep from scattering debris, blow around the outer edges
of a debris pile. Never blow directly into the center of a pile.
Use rakes and brooms to loosen debris before blowing. In
dusty conditions, slightly dampen surfaces when water is
available.
Watch out for children, pets, open windows, or freshly washed
cars, and blow debris safely away.
After using blowers or other equipment, CLEAN UP! Dispose
of debris properly.
MAINTENANCE
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which could result in serious personal
injury.
WARNING:
NEVER IMMERSE OR EXPOSE YOUR BATTERY PACK
TO CORROSIVE OR CONDUCTIVE FLUIDS OR ALLOW
THESE FLUIDS TO FLOW INSIDE THE BATTERY PACK.
6 — English