Resetting The Accumulated Battery Use Time Indication; Changing The Compander Time Constant - Sony WRT-847A Mode D'emploi

4
Once the desired level appears, set the POWER switch
to off position to release Setting mode, or press the SET
button to continue operations in Setting mode.
The next time you turn on the transmitter (by setting the
POWER switch to ON), the transmitter enters Transmitting
mode with the audio gain selected.
Changing the audio gain in Transmitting mode
You can also change the audio gain while transmitting.
1
If the audio gain indication is not displayed, press the
SET button until it appears.
2
Press the + or – button to change the audio gain setting.
Resetting the Accumulated Battery Use
Time Indication
The accumulated battery use time is the total time (in hours
and minutes) the batteries have been used. It is recorded
whenever the transmitter is on.
Reset the indication to "00:00" whenever you replace the
batteries.
1
Set the transmitter to Setting mode.
2
If the accumulated battery use time (for example
"01:50") is not displayed, press the SET button until it
appears.
3
Press the – button.
The indication resets to 00:00.
– button
AF RF BATT
To go back to the previous value, press the + button
while the "00:00" indication is on.
4
Set the POWER switch to the off position to release
Setting mode, or press the SET button to continue
operations in Setting mode.

Changing the Compander Time Constant

The transmitter provides two levels of the compander time
constant to get the best sound quality of the microphone
capsule unit.
The recommended settings are;
"S" (short) : CU-F780 / G780
"L" (long) : CU-E700 / E672 / F117
AF RF BATT
11
(GB)