Changing The Transmitting Channel - Sony WRT-847A Mode D'emploi

Changing the Transmitting Channel

The transmitting channel can be selected through either the
channel number or the frequency.
1
Set the transmitter to Setting mode.
If the channel number (or frequency) indication does not
appear, press the SET button until the channel number
(or frequency) indication appears.
2
Press the + or – button to select the channel number (or
frequency).
Pressing the + button cycles the indication in the order
shown in the tables in the "Sony Wireless Microphone
System Frequency List" supplied with the manual.
Pressing the – button cycles the indications in the
opposite direction.
Hold down the button to change the channel number (or
frequency) quickly.
Note on the model available in Europe
On the model available in Europe, select the group
number before selecting the channel number as follows.
1) When the left two digits flashes, select the group
number by pressing the + or – button.
2) When the desired group number appears, press the
SET button.
The right four digits starts to flash for channel
number selection.
3) Select the channel number by pressing the + or –
button.
4) When the desired channel number appears, press the
SET button.
Group selection Channel
mode selection mode
m: M :
+ button – button
Group, channel and frequency selection examples for the
model available in Europe (CE62)
3
When the desired channel number (or frequency)
appears, set the POWER switch to off position to
release Setting mode, or press the SET button to
continue operations in Setting mode.
Frequency
selection mode
9
(GB)