Using Your Outdoor Side Burner; Lighting The Side Burner - KitchenAid 760-0023 Instructions D'installation Et Guide D'utilisation Et D'entretien

USING YOUR OUTDOOR SIDE BURNER

Lighting the Side Burner

1. Open the lid completely.
Make sure control knob is turned to "○".
2.
3. Turn the gas supply on.
Natural gas or LP gas from a local supply
◼
Using gas supply source other than 20 lb LP gas fuel tank:
Turn the shutoff valve to open position from the front of
gas supply line. The valve is open when the handle is
parallel to the gas pipe.
20 lb LP gas fuel tank
See the "Gas Supply Requirements" section.
◼
Using a 20 lb LP gas fuel tank:
Slowly open the tank valve.
NOTE: If flow limiting device activates, your grill may not
light. If your grill does light, the flames will be low and will
not heat properly. Turn tank valve and all control knobs off
and wait 30 seconds. After shutting off the tank, very
slowly open tank valve and wait 5 seconds before lighting.
4. Do not lean over the side burner. Push in and turn the
burner knob to " " and hold in. The burner will light
immediately. When burner is lit, turn knob to desired
setting.
IMPORTANT:
If burner does not light immediately, turn the burner knob to "○"
and wait 5 minutes before relighting.
Manually Lighting the Side Burner
1. Open the lid completely.
2. Remove the manual lighting extension and attach a match
to the split ring.
3. Strike the match to light it.
4. Guide the lit match to the burner to light
5. Do not lean over the side burner. Push in and turn the
burner knob to "
The burner will light immediately. When burner is lit, turn
knob to desired setting.
6. Remove match and replace manual lighting extension on
the right side panel.
IMPORTANT:
If burner does not light immediately, turn the burner knob to "○"
and wait 5 minutes before relighting.
If any burners do not light after attempting to light them
manually, contact the Customer Service Center. See the
"Assistance" section.
21
" for the burner closest to the lit match.