GYS NEOCOOL Mode D'emploi page 18

COLD UNIT START-UP
For the first application, the pump start-up could be diffcult and generate a defect water flow. To start it correctly, it is recommended to use the
above hose and follow the instructions below to purge the system:
Fill the cooling unit to its maximum level to facilitate priming.
EXAGON / TITAN :
- Connect the quick coupling to the cold water outlet of the unit and place the other end in an empty container (ideally a bottle)
- Connect a torch to the product, then briefly squeeze the trigger to start the pump
- Once the pump is activated (container that fills with coolant), stop the product by turning off the main welding generator switch.
- Disconnect the start pipe, put the liquid back into the cooling unit and connect the beam correctly (see user manual of the welding generator).
TITANIUM / NEOPULSE / NEOFEED :
- Connect the quick coupling to the cold water outlet of the unit and place the other end in an empty container (ideally a bottle)
- In the « Settings/Cooling unit » menu, press the icon
- Once the pump activated (container that fills with coolant), stop the cooling unit by pressing one of the buttons on the HMI.
- Disconnect the starting pipe, put the liquid back into the cooling unit: your pump is started.
TROUBLESHOOTING
These devices integrate a default management system.
This allows the operator to diagnoses errors and anomalies. Refer to the instruction manual of the welding machine or the wire feeder (Troubleshoo-
ting chapter).
WARRANTY
The warranty covers faulty workmanship for 2 years from the date of purchase (parts and labour).
The warranty does not cover:
• Transit damage.
• Normal wear of parts (eg. : cables, clamps, etc..).
• Damages due to misuse (power supply error, dropping of equipment, disassembling).
• Environment related failures (pollution, rust, dust).
In case of failure, return the unit to your distributor together with:
- The proof of purchase (receipt etc ...)
- A description of the fault reported
18
All manuals and user guides at all-guides.com
NEOCOOL / EXACOOL / WCU1KW C / TWINCOOL
to start the start-up procedure.
EN