Publicité
Les langues disponibles
Les langues disponibles
5 Your unit can only be used by one
person at a time.
6 Use suitable clothing and footwear.
Make sure all laces/cords are tied
correctly.
1. ASSEMBLY
INSTRUCTIONS.-
Take the unit out of its box and make
sure that all of the pieces are there:
The assistance of a second person
is advisable for the assembly work.
(40) Main body; (13) handlebar stem;
(20) Stabiliser bar with wheels; (30)
Stabiliser bar with adjustable blocks;
(2) Monitor with handlebar; (25) and
(31) Saddle post covers; (33) Saddle;
(39) Saddle
post;
(44R) Right pedal; (41) Saddle height
adjustment
knob;
transformer; Bag of screws containing:
(85) Self tapping screw ST4.0x14; (86)
Flatwashers M4x16; Double ended
spanner;
Box
screwdriver; Allen key 6mm.
2. FITTING THE STABILISER
BARS.-
Rest the main body on a wad of
packaging, as shown in Fig.2 (this will
help with the assembly work). Take
hold of the front stabiliser bar fitted
with wheels (20).
Remove the bolts (26) and their nuts
and washers. Now line up the two red
dots, as shown in Fig.2, and refit the
bolts (26), nuts and washers. Tighten
securely.
Next, take the finish trim piece for
stabiliser (25) and rest it on the
stabiliser bar with wheels (20) that you
have just assembled. Attach the trim
to
the
bottom
threaded screws (85) and flat washers
(86).
(44L) Left pedal;
(87)
Mains
spanner
with
using
the
plastic
Next, rest the main body on a wad of
packaging
assembly easier).
stabiliser with adjustable feet (30) and
position it on the machine's rear stand,
insert the bolts (26) with the flat
washers and nuts, tighten securely.
Then take the finish trim piece for
stabiliser (31) and rest it on the
stabiliser bar (30) that you have just
assembled. Attach the trim to the
bottom using the plastic threaded
screws (85) and flat washers (86),
Fig.3.
3. ATTACHING THE PEDALS.-
The assembly instructions for the
pedals must be followed to the letter,
fitting these incorrectly could damage
the screw thread on the pedal or the
crank. Right and left refer to the
position that the user adopts when
sitting on the saddle to do the
exercises.
The right-hand pedal (44R),, marked
with the letter (R), screws onto the
right-hand crank, also marked with an
(R), in a clockwise direction. Tighten
securely, Fig.4.
The left-hand pedal (44L), marked
with the letter (L), screws onto the left-
hand crank, also marked with an (L),
in an anti-clockwise direction. Tighten
securely Fig.4.
4. FITTING THE HANDLEBAR
STEM.-
Connect the two terminals (16 and 18)
Fig.5, coming out of the handlebar
stem (13) and the main body (40).
Insert the handlebar stem (13) onto
the boss on the main body (40) taking
care not to pinch the cables.
10
material
(this
Take the
makes
rear
Publicité
