First Operation - Q&C NANO Guide De L'utilisateur

Installation
(Leakage Check & Power-On)
EN
Once everything is connected, carefully check the installation for any leaks.
1 Open Filter Head 2 Open Angle stop valve adapter
Open the filter head valve if it is in the Open the angle stop valve adapter if it is in
closed position. the closed position.
5
4 Power ON
Once the connection to the main water
supply is complete, you can connect your
Nano to the power socket. Nano will
start automatically as soon as the power
is connected.
Note: there is no ON/OFF button on the
Nano.
10
3 Open Angle stop valve
Slowly open the angle stop valve. If you
notice any leaks, fully close the angle stop
valve, tighten any leaking connectors, and
then try again.
1
11

First Operation

For optimal water quality and hygiene, the Nano flushing program starts automatically when it is first turned on.
This program will fill the internal cold water tank and flush the internal parts of Nano and filter cartridge.
Place a large pitcher or pot under the tap.
1
2 Follow the instructions on the Nano display.
As soon the program has finished, you can remove the pitcher
3
and replace it with the magnetic drip tray.
Your Nano is ready to use!
4
Connect Nano to the cloud to access all the functions. Check your daily water intake, get notifications about
your filter life, set up energy-saver mode, and more. Scan the QR code to use the Q&C mobile app.
Scan the QR code
1
Or type and go to this URL:
qcwatercoolers.com/mobile-app
Install Q&C App
2
Install our app. You'll find all the instructions in the application
to connect and set up your Nano.
EN
11