Electrical requirements
Electrical Shock Hazard
Enclose dishwasher completely on the top,
sides, and rear.
Failure to do so can result in death or
electrical shock.
Read and follow the "Electrical requirements,"
"Water
Do not use an extension cord.
requirements,"
and "Drain requirements"
sections before
Failure to do so can result in death, fire,
installing dishwasher.
or electrical shock.
Tools and materials needed for
installation:
l
electric drill
l
Phillips screwdriver
l
2 adjustable wrenches
l
flat-blade screwdriver
l
measuring tape
l
key hole saw
l
tubing cutter (not shown)
l
pipe-joint compound
l
3 twist-on wire connectors
for 16-gauge wire
l
pliers
l
90" elbow with 3/e" N.P.T.
l
wire stripper and utility knife
external threads on one
end. The size of the other
l
%s" and l/4" nut driver or hex
end must fit your water
socket
supply line.
l
pipe wrench
Electrical Shock Hazard
Electrically ground dishwasher.
Connect ground wire to green ground connector
in terminal box.
A 120-volt, 60 Hz, AC only, 15- or 20-ampere, fused,
electrical supply is required. Time-delay fuse or circuit
breaker is recommended.
It is recommended
that a
separate circuit serving only this appliance be provided.
The dishwasher
must be connected with copper wire only.
Wiring methods
Pick one method to follow depending
upon your dishwasher
and local codes.
A. Direct wire method (cable con-
necting dishwasher to a junction box)
Recommended grounding method
1.
Disconnect
power.
2. Run flexible, armored or nonmetallic
sheathed, copper
cable (with grounding wire) from the fused disconnect,
circuit breaker or junction box through the %I" cabinet
hole to the dishwasher
location. The cable must extend
24" from the back wall.
The hole cut through a wood cabinet should be sanded
until smooth.
The hole cut through a metal cabinet must be covered
with a grommet (Part No. 302797), available from your
dealer or parts supplier.
A U.L.-listed strain relief or conduit connector must
be installed at each end of the power supply cable
(at the dishwasher
and at the junction box). Wire sizes
(COPPER WIRE ONLY) must conform with the rating
of the dishwasher.
Parts supplied for installation:
l
2 drain hose clamps
l
drain hose
l
2 No. 10 x l/2" Phillips-head
screws
(continued)
3369671 -C
3