Before Initial Use - Beem ESPRESSO PERFECT 03260 Mode D'emploi

EN

Before Initial Use

NOTICES
• Never remove the rating plate and any possible warnings!
• Always set up the device with a clear space at the sides (at least 20 cm) and clear space
above it (at least 30 cm) on a fl at, solid and heat-resistant surface that is resistant to
splashing.
• Do not place the device below kitchen wall units or similar cupboards. The rising steam
could cause damage to them!
• The surfaces of furniture may possibly contain elements which can attack and soften the
adjustable feet of the device. If necessary, place a suitable pad below the adjustable feet.
• There may still be some production residues on the device. To avoid harmful effects
to your health, clean the device before you fi rst use it (see the "Cleaning and Care"
chapter).
1. Remove all packaging materials and any possible protective fi lms used for protection during
transportation.
2. Wipe the device with a clean, damp cloth. Clean all parts with a little mild detergent and clear
water.
3. Place the device in a suitable location, following the safety instructions and the notices provid-
ed at the beginning of this chapter.
4. Pull the mains cable out of the cable compartment and plug it into a properly installed, easily
accessible plug socket.
5. Before you enjoy your fi rst espresso or coffee, we recommend that you carry out a trial run
to remove any possible production residues in the water system. To do this, follow the instruc-
tions in the "Handling and Operation" and "Preparation" chapters.
When the device is fi rst used, production-related additives (e.g. grease) may cause a small
amount of smoke and / or an odour to be produced. This is normal and not a device defect.
6. Repeat this process twice. Caution! Do not drink this espresso / coffee!
7. Clean the device and accessories (see the "Cleaning and Care" chapter).
03260_DE-EN-FR-ES-IT_Inlay_A5_V1.indb 30 03260_DE-EN-FR-ES-IT_Inlay_A5_V1.indb 30
30
26.09.2018 10:26:40 26.09.2018 10:26:40