Warranty And Limitations Of Liability - Beem ESPRESSO PERFECT 03260 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

41
Problem
Despite a pumping
noise, no water
comes out of the
device.
The espresso / coffee
runs very slowly into
the cup.
A large amount of
steam is produced in
the brewing process.
During use, an
unpleasant smell is
detected.

Warranty and Limitations of Liability

The warranty excludes any defects caused by improper use, calcifi cation, damage or repair
attempts. This also applies to normal wear and tear.
We do not accept any liability for damage or consequential damage resulting from:
Failure to follow the operating instructions
Non-designated use
Improper or unsuitable handling
Repairs which are not carried out properly
Unauthorised modifi cations
Use of outside parts or spare parts
Use of unsuitable additional parts or accessories
03260_DE-EN-FR-ES-IT_Inlay_A5_V1.indb 41
03260_DE-EN-FR-ES-IT_Inlay_A5_V1.indb 41
Possible cause
There is no water in the water
tank.
The water tank is inserted
incorrectly.
The espresso / coffee powder is
pressed too fi rmly.
The espresso / coffee powder is
too fi nely ground.
The device is furred up.
The device is furred up.
The device is being used for the
fi rst time.
The device has previously been
descaled.
Fix
Fill the water tank.
Take out the water tank and
insert it again. Make sure that it
fi ts correctly.
Only press down the espres-
so / coffee powder lightly.
Use espresso / coffee powder
with a coarser grinding fi neness.
Descale the device (see the
"Cleaning and Care" chapter –
"Descaling").
Descale the device (see the
"Cleaning and Care" chapter –
"Descaling").
A smell often develops when
new devices are fi rst used. The
smell should disappear once the
device has been used several
times.
Rinse out the device with clear
water.
26.09.2018 10:26:42
26.09.2018 10:26:42
EN

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Espresso perfect cm4637ag-gs

Table des Matières