Operation And Use; Filling With Water - Beem Fresh-Aroma-Perfect Deluxe V2 Mode D'emploi

BEEM - Elements of Lifestyle
28 Button
2 - 10
(setting the number of cups)
29 Button
2 - 4
(for extra strong coffee)
30 Button (Switching the reminder for
the activated carbon filter replacement
on/off)
31 Button
(setting the hours)
32 Button
(setting the minutes)
33 Cable compartment (back of the appli-
ance)
34 User manual
(not illustrated)

Operation and use

Switching on the display lighting
The blue display lighting goes out 60 sec-
onds after the last keypress except when the
appliance is in operation, e.g. coffee is being
brewed or kept warm.
1. Press any key to switch on the display
lighting.
NOTE
► Only press the button for the desired
action after the lighting goes on.
Setting the time
1. Insert the plug into the mains socket. The
time 12:00 starts flashing on the display.
2. Set the hour by pressing the
(31).
3. Set the minutes by pressing the
ton (32).
NOTE
► The time will be stored until either a
new time is entered or the plug is removed
from the socket for more than a minute.

Filling with water

(image A1)
1. Open the water tank lid (3).
2. Only fill the amount of water required for
the desired number of cups.
All manuals and user guides at all-guides.com
3. Close the water tank lid (3).
►
is always used, independent of the number
of cups or the strength of coffee set.
►
tor (11) in the water tank. Do not overfill!
1. Take the lid off the coffee bean compart-
ment (1).
2. Make sure that the water tank lid (3) is
closed to prevent coffee beans from falling
into the water tank.
3. Fill the coffee bean compartment (2) with
coffee beans. Do not overfill!
4. Put the lid (1) back onto the coffee bean
compartment (2).
►
ground coffee of the previous variety is still
in the grinder shaft. If necessary, clean the
grinder shaft as described in the section
Cleaning the grinder shaft (pag. 21).
1. Press the release button (5) to open the
filter compartment (8).
2. Put the filter insert (9) into the filter com-
partment (8).
3. Put the permanent filter (10) into the filter
insert (9) (image A2).
4. Close the filter compartment (8).
button
but-
1. Press the
the desired number of cups appears in the
display.
The following settings are possible:
2, 4, 6, 8, or 10 cups.
►
until either a new number of cups is
entered or the plug is removed from the
socket for more than a minute.
NOTE
The entire amount of water in the tank
Pay attention to the filling level indica-
Filling with coffee beans
NOTE
When changing the coffee bean variety,
Inserting the filter
(image A2)
Setting the number of cups
button (28) repeatedly until
2 - 10
NOTE
The number of cups set will be stored
EN 17