Faber STRATUS WH 36 Instructions D'installation page 14

10
Open the filter cover panel. The filter cover panel
is held by a magnet catch, pull down with enough
force to release as shown above.
12
A. Home power supply cable
B. Black wires
C. UL listed wire connectors
D. White wires
E. Green (or bare) ground wire from home power supply connected to green ground screw
F. Range hood power supply cable
14
A
B
C
D
F
11
Remove the grease filters one at a time, pushing
the towards the back of the unit, and at the same
time pulling downward and set aside.
Installation of wiring
Remove the cover from the
field wiring compartment.
DO NOT turn on the power until
installation is complete!
Connect the Power Supply
Cable to the rangehood.
Connect the Green (Green and
Yellow) ground wire under the
Green grounding screw. Attach
the White lead of the power
E
supply to the White lead of the
rangehood with a twist-on type
wire connector.
Attach the Black lead of the
power supply to the Black lead
of the rangehood with a twist-
on type wire connector.
Replace the field wiring compart-
ment cover and the grease filters.
connection