Cooper Lighting Solutions Galleon Instructions D'installation page 2

Installation Instructions – Galleon Quick Connect Arm
INSTALLATION
Care must be taken not to set lighting fixture down
N ote:
on optical lenses or lift the fixture in the lens area.
Tools Required
Ratchet, a shallow 3/4" socket and 1/4 hex nut driver; 3/8"
Allen drive for 1/2" inch bolt; #2 Phillips head screw driver;
torque wrench
Factory Installed Housing Side Arm - Option
(Figure 1. – Figure 5.)
1. Pole mounting arm is designed for a square or round
pole. Round pole installation will require the mounting
arm break away tabs to be removed. Grab break away
tab with pliers and break-away the tabs. (Figure 1.)
Pole Mounting Arm
Figure 1.
2. Mount the arm to the round or square pole using the
provided 1/2" x 1-3/4" long bolts and nuts. Torque bolts
to 40 foot-lbs. (55 N-M). (Figure 2.)
Figure 2.
3. Slide fixture onto pole mounting arm. For QM and
QMEA arms: Tighten the center Philips head screw to
20 in-lbs. (2.3 N-M). For QML arm: Install the (3) 1/4-20
x 1.25" screws and tighten to 8 ft-lbs, tightening the
center screw first. (Figure 3.)
2
Cooper Lighting Solutions
For Round Pole
Installations, Break
Off Tabs
For Round Pole
Installations, Break
Off Tabs
IB500004EN
Installation instructions
House Sided Arm
Pole Mounting Arm
Figure 3.
4. Make wire connections inside the mounting arm. Refer
to wire diagram for power connections. Connect the
supply wires to appropriate luminaire leads. (Figure 4.)
• Supply side ground wire to green luminaire lead.
• Supply side neutral wire to white luminaire lead.
Supply side line voltage wire to black luminaire lead.
•
Line (Black)
White Common
(Black 480V)
Green Ground
Figure 4.
5. Install arm cover and tighten Philips head screws to 20
in-lbs (2.3 N-M).
N ote: Ensure the luminaire supply leads do not get pinched
between cover and mounting arm. (Figure 5.)
Figure 5.
6. Install pole cap after completion of luminaire installation
and wiring.
Black
White (Black 480V)
Fixture
Green Ground