Axis Q87 Serie Guide D'installation page 25

AXIS Q87 Bispectral PTZ Network Camera Series
1. Disconnect power from the product.
2. Loosen the four top cover screws and remove the top cover.
3. Change the position of the Factory default switch.
4. Replace the top cover and tighten the screws (torque 2.0 Nm).
5. Reconnect power to the product.
You can also reset parameters to factory default through the product's webpages. Go to Settings
> System > Maintenance and click Default.
All manuals and user guides at all-guides.com
25
EN