Publicité
Les langues disponibles
Les langues disponibles
5
INSTALL OUTER
CASE IN WINDOW
Place outer case in window. Lower sash
until it rests behind front flange of top rail.
Bottom rail must rest behind window sill.
Window sash
SILL
Expand both curtains to contact the
window frame. Install five 25-mm screws
through curtains and top rail. Install two
outer case anchor screws into window sill.
NOTE: To make screws easier to drive, drill
a 1/8” diameter pilot hole into sash through
clearance hole in curtains and top rail.
6
INSTALL
BASEPAN
ANGLE &
WINDOW SEAL
GASKET
Position baspan angle flush against
outercase. Drive 25-mm screws into
window ledge to prevent unit from
moving.
Cut window seal gasket to width of
window. Stuff window seal strip
between outdoor window glass and
top of indoor sash. This will stop air
leakage which reduces efficiency.
All manuals and user guides at all-guides.com
Level
Install outdoor supports on under side
Curtain assembly
of outer case. Mount outdoor
removed for clarity.
supports as close to sill as possible.
CAUTION: Use a hard wood block
between the adjusting foot and the
surface it may contact. This will
protect the surface from damage.
Turn each adjusting foot until it
begins to contact wood block. With a
level adjust unit to a 1/2 bubble slope
to the rear for proper water drainage.
11
25-mm
screws
Basepan
angle
Publicité
