Harol OB910 THERMO IR Notice De Montage page 29

OB910 THERMO IR MOUNTING INSTRUCTIONS
3.4. Installing the roller shutter box
3.4/1
• Attach the compression strip (not included in
delivery) all around.
3.4/2
• Place the window in the opening.
• Align the window.
• Fix it in position.
3.4/3
• Lower the roller shutter by approx. 10 cm.
• Remove the transport lock on both sides.
Note: If support brackets are present, they must be
attached in one of the following ways:
The brackets can be screwed in 3 different ways:
3
1
2
1. Along the front of the box
2. Along the inside of the box
3. Via an L-profile on top of the box
NOTE: The top surface of the bracket must fit nicely
over its entire length with the top of the box!
1
3
2
01/19 | EN | 29