Publicité
Les langues disponibles
Les langues disponibles
HOOHUpS
Instal
Electrical
Connection--Direct
Wire Method
1. Drill a 3/4"(1.9 cm) hole in the right-hand cabinet side or the
rear of the opening.
2.
If the cabinet is wood, sand hole until smooth. If the cabinet is
metal, cover the hole with a grommet (Part Number 302797)
included with power supply cord kit. See "Electrical
Requirements."
Install Water Line
1. Drill a 1/2= (1.3 cm) hole in the left-hand cabinet side or the rear
of opening.
A
B
A
B
A. Optional locations
B. Preferred locations
2. If the cabinet is wood, sand the hole until smooth. If the
cabinet is metal, cover the hole with a grommet (not provided).
3. Route the wire from the power supply through the cabinet
hole. The wire must extend to the front right-hand side of the
cabinet opening.
4. Tape the wire to the floor in the area shown. This will keep the
wire from moving when the dishwasher is moved into the
cabinet opening.
A. 6" (15.2
cm)
Install Electrical Connection-- Power Supply Cord
Method
NOTE: A mating, grounded 3 prong outlet is required in a cabinet
next to the dishwasher opening.
1. Drill a 11/2= (3.8 cm) hole in the cabinet side or the rear of the
opening.
A. Preferred locations
B. Op rional Io ca tio ns
2. Measure the overall length of the water line (copper tubing or
flexible braided water supply line) required.
3. Attach the water line (copper tubing or flexible braided water
supply line) to the hot water supply line in compliance with
local codes and ordinances.
4.
NOTE: The hot water supply line should have a manual
shutoff valve.
Slowly route the water line (copper tubing or flexible braided
water supply line) through the hole in the cabinet.
NOTE: Copper tubing will bend and kink easily.
The water line (copper tubing or flexible braided water supply
line) should be far enough into the cabinet opening to connect
to the dishwasher inlet on the front left-hand side of the
dishwasher.
;.5,-,
A
B
A. Optional locations
B. Preferred locations
m
6
Publicité
