Publicité
Les langues disponibles
Les langues disponibles
3. Form a U-shaped hook on the bare ground wire.
4. Wrap the ground wire hook clockwise around the green
grounding screw and under the washer.
5. Tighten the green grounding screw.
C
10. Using a 1/4"nut driver and previously removed screw, reinstall
the terminal box cover with the wires inside terminal box.
%
6=
7=
A. Bare ground wire
B. Washer
C. Green grounding
screw
Using UL-listed/CSA-approved
twist-on connectors sized to
connect direct wire to 16-gauge dishwasher wire, connect the
white wire from the power supply to the white wire on the
terminal box.
Using UL-listed/CSA-approved
twist-on connectors sized to
connect direct wire to 16-gauge dishwasher wire, connect the
black wire from the power supply to the black wire on the
terminal box.
/
/
11. Check that no wires are pinched by the cover.
At<ixck Ds
she < gcc bne$
Tip Over Hazard
Do not use dishwasher
until completely installed.
Do not push down on open door.
Doing so can result in serious
injury or cuts.
1. Check that dishwasher is still level front to back and side to
side in the cabinet opening.
8. Tighten the conduit connector screws.
NOTE: Make sure the screwheads are facing to the left when
tightening the conduit nut.
9. Insert tabs on the left-hand side of the terminal box cover.
15
Publicité
