Spektrum AR6410 Guide De L'utilisateur page 11

To Change Channel 6 to a Reversed Channel 2 for Dual Ailerons
or Reversed Channel 2 to Channel 6
Sticks must be held in this position while the transmitter is on and the
receiver is off.
1. Ensure a successful bind was completed
2. Turn transmitter on
3. Move THRO stick to full throttle position
4. Move Control sticks to the corresponding position to change between the
available options (see illustration)
5. While holding this position, plug the battery into the receiver; power on receiver
6. The LED on the receiver will go solid and within 5 seconds, the LED will flash 3
times quickly, indicating the option is now changed
7. Disconnect flight pack from receiver
8. Turn transmitter off
Mode 1
THRO/RUDD ELEV/AILE
To Change the Brushed Motor to Operate an Optional Brushless Motor
ESC or Brushless to Brushed Motor Control
The AR6410/AR6410L is capable of operating brushless motors with the use of an
optional brushless ESC, please see the illustration below for instructions.
Sticks must be held in this position while the transmitter is on and the
receiver is off.
1. Ensure a successful bind was completed
2. Turn transmitter on
3. Move THRO stick to full throttle position (see illustration)
4. Move Control sticks to the corresponding position to change between the
available options (see illustration)
5. While holding this position, plug the battery into the receiver; power on receiver
6. The LED on the receiver will go solid and within 5 seconds, the LED will flash 3
times quickly, indicating the option is now changed
7. Disconnect battery from receiver
8. Turn transmitter off
Rev. CH2/CH6
1. Full THRO
2. Up ELEV
3. Left AILE
11
Mode 2
ELEV/RUDD THRO/AILE
EN