Publicité
Les langues disponibles
Les langues disponibles
Description
The numbers in the text refer to the diagrams on
pages 2-3
Fig. A
1. On/off switch
2. D rill selection switch
3. Hammer selection lever
4. Chuck
5. Locking sleeve
6. Main grip
7. Auxiliary grip
8. Carbon brush cover
9. Lubrication point
3. ASSEMblY
Before assembly, always switch off the
machine and remove the mains plug
from the mains.
Mounting and removing the accessory
Fig. B
Do not use blunt drill bits or chisels.
Immediately sharpen or replace blunt
drill bits or chisels.
Mounting
• A pply a few drops of oil to the shaft of the
accessory.
• S lide the locking sleeve (5) to the rear.
• I nsert the accessory into the chuck (4).
• S ecure the accessory by turning it
counterclockwise until it locks into place.
• R elease the locking sleeve (5).
Removing
• S lide the locking sleeve (5) to the rear.
• R emove the accessory from the chuck (4).
• R elease the locking sleeve (5).
Mounting and removing the auxiliary grip
Fig. C
Mounting
• L oosen the auxiliary grip (7) by turning it
counterclockwise.
• M ount the auxiliary grip (7) by sliding it over the
chuck (4).
6
HDM1028 Ma 1611-07.indd 6
All manuals and user guides at all-guides.com
• T urn the auxiliary grip (7) to the required
• T ighten the auxiliary grip (7) by turning it
Removing
• L oosen the auxiliary grip (7) by turning it
• R emove the auxiliary grip (7).
• T ighten the auxiliary grip (7) by turning it
Mounting and removing the dust collector
Fig. D
The dust collector prevents dust from entering the
machine when drilling into ceilings.
Mounting
• I f necessary, remove the accessory from the
• S lide the dust collector (15) over the shaft of
• I nsert the accessory with the dust collector
Removing
• R emove the accessory with the dust collector
• R emove the dust collector (15) from the
4. USE
Switching on and off
Fig. A
• T o switch on the machine, press the on/off
• T o switch off the machine, release the on/off
Setting the operating mode
Fig. A & E
The drill selection switch and the hammer
selection lever must be set according to the
required operating mode. Refer to the table below
to set the required operating mode.
position.
clockwise.
counterclockwise.
clockwise.
Immediately replace a damaged dust
collector.
chuck (4).
the accessory.
(15) into the chuck (4).
(15) from the chuck (4).
accessory.
switch (1).
switch (1).
Setting Op
Fig. E
A D emolit
B Hamme
C D rill
• T urn the
hamme
position
Hints for o
• C lamp
for sma
• F irmly h
• S et the
• S witch
• D o not
machin
• S witch
machin
before p
5. ClE
MA
Clean the m
cloth, prefe
the ventilat
dirt. Remo
cloth mois
solvents su
etc. Chem
synthetic c
Checking
Fig. A
The carbon
If the carbo
start to run
• R emov
screwd
23/11/16 16:35
B
sw
m
O
b
Publicité
