Publicité
Les langues disponibles
Les langues disponibles
BT TRANSMITTER MODE
Pairing to a BT speaker
The CD player can act as a BT transmitter to a BT speaker. Follow the below
steps to connect to a BT speaker and play music from a loaded CD. When
the CD player is stopped for approximately 10 seconds, the power will be
Automatically turn off,The user will need to repeat below connection steps to
play in BT mode again:
1. Press and hold the A-B/BT BUTTON to switch to BT Pairing Mode.
2. When CD player is in BT mode, "BT" will be seen flashing on the LCD
display. The pairing process could take up to 30 seconds. For best results,
stay within 3 ft. of the BT speaker you are pairing to.
3. When the BT connection is made, the "BT" icon on the LCD display will
stop flashing and turn solid, Your BT speaker should indicate when the
connection has been made as well.
Begin playing music on the CD player to hear it on the connected BT
speaker. If you are connected to a BT speaker with a play/pause button and
do not hear audio, try pressing the PLAY/PAUSE BUTTON.
4. When you are finished listening, Press the STOP BUTTON to stop the
player.
5. Press and hold the A-B/BT BUTTON to turn off BT transmitter mode.
CARE AND MAINTENANCE
Clean the unit with a soft, damp (never wet) cloth. Solvent or detergent should
never be used.
During CD play, or if the CD fails to play at all, its bottom surface may require
cleaning. Before playing, wipe the disc from the centre outwards with a lint-
free soft cleaning cloth.
Attention: Never allow any water or other liquids to get inside the unit while
cleaning.
EN
25
Publicité
