Publicité
Les langues disponibles
Les langues disponibles
EN
20
POWER SOURCE
Power supply
This CD player operates on two 1.5 V DC "AA" size (UM-3) alkaline batteries
(not included) or AC USB adaptor with an output of 4.5 V DC 500 mA (not
included).
Install batteries into the player
1. Open the battery compartment cover located on bottom of cabinet.
2. Insert two 1.5 V DC "AA" size (UM-3) alkaline batteries (not included) into
the battery compartment following the polarity markings as indicated in
the compartment.
3. Close the battery door.
Important: Be sure that the batteries are installed correctly. Wrong polarity
may damage the unit and void the warranty.
Battery note and care
1. Danger of explosion if the battery is replaced incorrectly. Replace only
with the same or equivalent type
2. Do not mix old and new batteries.
3. Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-
cadmium) batteries.
4. If the unit is not to be used for an extended period of time, remove the
batteries. Old or leaking batteries can cause damage to the unit and may
void the warranty.
5. Do not try to recharge batteries not intended to be recharged; they can
overheat and rupture. (Follow battery manufacturer's directions).
6. Do not dispose of batteries in fire, batteries may leak or explode.
Using an USB adaptor (not included) to power the unit)
1. Before connecting the adaptor to the player, make sure that the AC
voltage of the adaptor corresponds to you local AC outlet voltage. The
polarity of the adaptor must match to the polarity markings next to the
USB jack on the player.
2. Plug the 4.5 V DC 500 mA AC-DC adaptor into an AC outlet.
3. Insert the DC plug into the DC IN jack on the player.
NOTE: When the USB adaptor is connected, the batteries will be
automatically disconnected and the player will now operate
on the adaptors power. Once the adaptor is unplugged the
player will automatically switch to back to battery power.
Publicité
