EN
22
OPERATION
Turning Unit Power On and Off
• The display will show "no disc".
• To turn ON the unit, press the PLAY/PAUSE button, the LCD display will
be on and then read the inserted disc. If no disc is inserted or the inserted
disc has an error, to turn OFF, in CD stop mode press and hold the STOP
for 3 seconds, display will go off.
NOTE: When the unit is stopped for approximately 10 seconds, the
power will automatically turned off.
Play Mode
1. In power off mode, press the CD door OPEN switch to open the CD door.
2. Insert a CD with the label side facing upward and then close the CD door.
3. Press the PLAY/PAUSE button to turn on the unit. Total number of
tracks and playing time in sequence and then start to play first track
automatically.
4. While playing, press the PLAY/PAUSE BUTTON to pause, the elapsed time
will flash. Press PLAY/PAUSE BUTTON again to resume playing
5. Rotate the VOLUME Up/Down to adjust volume level.
6. Press the STOP BUTTON to stop playing.
NOTE: Do not open the CD DOOR when a CD is playing.
To Enhance the Bass Sound: Set the BBS switch to the ON position.
NOTE: The bass boost performance will be increase or decrease
depending on the volume level.
Key lock
Move the HOLD slider on the back to the ON position to lock the buttons.
Slide it to the OFF position to unlock the buttons.
LCD information
At initial start up
• The disc will start playing and the display will show the playing time.
• The display will show the total number of tracks and total playing time.
The first track number & instant.
• To review the total number of tracks and total playing time of the disc,
press the STOP button once.
During PLAY mode
• The track number and the elapsed time are displayed.