Publicité
Les langues disponibles
Les langues disponibles
4. How to Control the Unit
You can operate the unit in three ways:
1. By master/slave built-in preprogram function
2. By easy controller
3. By DMX controller
No need to turn the unit off when you change the DMX address, as new DMX address
setting will be effected at once. Every time you turn the unit on, it will show "CP21" on the
display and move all the motors to their „home‟ position. After that the unit will be ready to
receive DMX signal or run the built in programs.
4.1 Master/Slave Built In Preprogrammed Function
The fixture will allow you to link 16 fixtures together and operate without a controller. In
Master/Slave mode, the first fixture whose DMX input jack has with nothing connect will be
master automatically, set other units to slave 1 or slave2 or ... slave 16 via menu, then the
first unit will control the others to give an automatic, sound activated, synchronized light
show. This function is good when you want an instant show. Any fixture can act as a Master
or as a Slave
4.2. Easy Controller (by CA-8)
The easy remote control is used only in master/slave mode. By connecting to
the 1/4" microphone jack of the first unit, you will find that the remote controller
on the first unit will control all the other units for Stand by, Function and Mode
selection
Blackout To blackout all the fixture
Function Strobe
1. Synchronous strobe
in white color
2. The same color chase
3. Different color strobe
Mode
Sound 1
(LED OFF)
4.3 DMX Controller
Use universal DMX controller to control the units, you have to set DMX address from 1 to
512 channels so that the units can receive DMX signal.
Select Color
Color 1-16 or
manual setting
color
Manual
Sound 2
(LED ON)
(LED slow blinking)
Select show
Select Chase
Show 1-12
Chase 1-16 or fade
Auto
(LED fast blinking)
Publicité
