Nicols IC4 LED Manuel D'utilisation page 20

3. How to Set the Fixture
3.1 Control Panel
 Display: To show the various menus and the selected functions
LED:
DMX
MASTER
SLAVE
SOUND
Button:
MENU
DOWN
UP
ENTER
Only for remote control: Connecting with CA-8 to control the unit for Stand by, Function
and Mode function.
Microphone: Receive music for the sound active.
DMX input: For DMX512 link, use 3/5-pin XLR plug cable to input DMX signal.
DMX output: For DMX512 link, use 3-pin XLR plug cable to link the next unit.
Mains output: Connect to supply mains power for the next unit.
Mains input: Connect to supply mains power.
3.2 Main Function
To select any functions, press MENU button until the required one is shown on the display.
Select the function by ENTER button and the display will blink. Use DOWN and UP button
to change the mode. Once the required mode has been selected, press ENTER button to
setup or it will automatically return to the main functions without any change after idling one
minute. Back to the functions without any change press MENU button. The main functions
are shown below:
On DMX input present
On Master Mode
On Slave Mode
Flashing Sound activation
To select the programming functions
To go backward in the selected functions
To go forward in the selected functions
To confirm the selected functions