GEHA Office X15 CD Manuel page 11

- Ensure that the correct voltage is used.
- Never use several extension cords.
- In case the device displays any unusual characteristics (e.g. strange smell or smoke),
immediately stop operating the device and remove the mains power plug from the wall
socket.
sETTING UP ThE fILE shrEDDEr
1. The centre of gravity is located in the top part of the device. Make sure to position the file
shredder on an even surface to prevent it from toppling over.
2. Never operate the device near sources of heat or cold, or in an overheated, moist or dusty
environment.
3. Place the device close to a wall socket and ensure easy access to the wall socket, in case
the device needs to be deactivated.
4. 1.Make sure that the waste paper container is pushed all the way into the device and that
the door is closed.
5. Connect the mains power plug to a regular 220-240 V AC wall socket.
sTrUcTUrE aND fUNcTIoN
1 Paper/CD, credit card slot
2 Button for setting the time
3 LCD display
4 Display 'Status'
5 Button for reversed operation/ time - (REV)
6 Button for forward operation/ time + (FWD)
7 ON/ OFF - switch
8 Door for waste paper container
8 Viewing window
9 Rollers
commIssIoNING ThE fILE shrEDDEr
a. feeding Paper into the Device
The device can shred a maximum of 15 sheets (A4, 70 g/m²) simultaneously. Switch on the
file shredder by pressing the ON/OFF button on the rear of the device. The green LED 'Status'
lights up, and the operating mode (Ready) and current time are shown in the LED display.
(See section C for setting the current time)
Manual_X15CD_Office.indd 11
11
15.07.10 15:39