Kenwood KVT-M707 Manuel D'installation page 9

■ Installation on Toyota Car using Brackets at Holes shown by "●"
When using the bracket shown above, you cannot use screws at two holes of the
right and left unit sides. If so, tighten the bracket using accessories 0 as shown
below.
1. Use accessories 0 at both sides as shown.
2. Mount the bracket at each side.
Accessory ! (M5x6mm)
Screws (included in
audio unit package)
3. Bend each end of accessory 0 to fix the bracket.
or
Audio unit or others
Accessory 0
Bracket
Use a flat-blade screwdriver or pliers, and bend
each accessory tab into the hole of installation
bracket to fix the bracket.
Accessory ! (M5x6mm)
Screws (included in
audio unit package)
9
|
English