Télécharger Imprimer la page

EINHELL TP-AG 18/125 CE Q Li Mode D'emploi page 17

Publicité

Les langues disponibles

Les langues disponibles

6.9 Roughing work (Fig. 7)
Important! Use the guard for grinding
(included in delivery). For the best results when
doing roughing work, apply the grinding wheel at
an angle of 30° to 40° to the grinding plane and
move it back and forth evenly over the workpiece.
6.10 Abrasive cutting (Fig. 8)
Important! Use the guard for cutting.
Do not tilt the angle grinder in the cutting plane
when performing cutting work. The cutting wheel
must have a clean cutting edge. To cut hard
masonry, it is best to use a diamond cutting
wheel.
Use on materials containing asbestos is
prohibited!
Never use cutting wheels for roughing
work.
Note:
For optimum results, use Power X-Change
rechargeable batteries with a capacity of over
4.0 Ah.
Important!
To increase the cutting performance and running
time of the cordless equipment, we recommend
that you use a cutting wheel with a thickness of
".
3
64
6.11 Removable dust guard (Fig. 9-11/Item 9)
The cordless angle grinder is equipped with a
removable dust guard in order to protect the
motor from too high a dust load. For cleaning
purposes, take off the removable dust guard (9)
as shown in Fig. 9, clean it with compressed air,
and refi t it on the tool as shown in Fig. 11.
7. Cleaning and maintenance
HAZARD!
Always take the battery out of the equipment
before starting any cleaning work.
7.1 Cleaning
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it down with compressed air at
low pressure.
Anl_TP_AG_18_125_CE_Q_Li_SPK7_USA.indb 17
Anl_TP_AG_18_125_CE_Q_Li_SPK7_USA.indb 17
EN
We recommend cleaning the equipment
immediately each time after use.
Clean the equipment regularly with a damp
cloth and some soft soap. Do not use
cleaning agents or solvents; these may
be aggressive to the plastic parts in the
equipment. Ensure that no water can get into
the interior of the equipment. The ingress of
water into an electric power tool increases the
risk of an electric shock.
7.2 Maintenance
There are no other parts inside the equipment
which require maintenance.
8. Disposal and recycling
The equipment is supplied in packaging to
prevent it from being damaged in transit. The
raw materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
9. Storage
Store the equipment and its accessories out
of children's reach in a dark and dry place at
above freezing temperature. The ideal storage
temperature is between 41°F and 86°F
(5°C and 30°C). Keep the electric tool in its
original packaging.
The reprinting or reproduction by any other
means, in whole or in part, of documentation
and papers ac-companying the products is
strictly subject to the express consent of Einhell
Germany AG.
Subject to technical changes.
- 17 -
01.08.2023 11:25:51
01.08.2023 11:25:51

Publicité

loading

Ce manuel est également adapté pour:

4431148