Abus eyseo ECOLINE Serie Manuel D'installation page 10

7. Installation
Proceed as follows when installing the camera.
1. Select a suitable place to mount the camera.
2. Connect the video cable (recommended type: RG59) with the BNC video
output (1) of the camera and with the output as the next connected device.
The maximum cable length must not exceed 200 meter.
3. Connect a 12VDC voltage supply to the power input (E 5.5x2.1).
4. Hold the camera at the location where you want to mount it later. Check the
orientation and viewing angle of the camera.
5. Fasten the supplied wall or ceilling mount to the desired installation location
and screw the mount into the camera housing.
6. Change the orientation of the camera bracket if necessary by slightly
loosening the fixing screw and changing the position as required. Then tighten
the fixing screw so that the camera remains in the desired position.
8. Technical Data
Model
Video norm
Image sensor
Pixel (total)
Pixel (effective)
Min. illumination
Infrared sensitivity
TV lines / Pixel
Infrarot LEDs
Infrared range
IR activation
Synchronisation
Video signal
Signal-noise-ratio
Day/night switching
Whitebalance
Lens
Auto-Iris
Backlightcompensation
Gamma
Operating temperature
Protection grade
Size / weight
Voltage / max. current
Security-Center, ABUS Group, D-86444 Affing, Germany
www.abus-sc.eu, info@abus-sc.eu
All manuals and user guides at all-guides.com
TV7182
1/3'' SONY HAD CCD Sensor
537(H)x597(V)
500(H)x582(V)
420 TVL / 291000
1Vss / 75 Ohm, composite
3.6mm / Miniature lens / F2.0
Active histogram plus windows weight BLC
12 VDC / max. 350 mA
5
PAL
795(H)x596(V)
752(H)x582(V)
0.05 Lux (IR off)
0 Lux (IR on)
400-850 nm
480 TVL / 437000
35 LEDs
15 meter
Automatic, under 10 Lux
Internal
> 52 dB
Black/white under 2 Lux
2400K – 11000K
1/50s – 1/100000s
0.45
-10°C - +50°C
IP68
Ø60 x 50 mm / ca. 430 g
12 VDC / max. 400 mA
TV7183