Axis T92A00 Guide D'installation page 9

AXIS T92A00 Installation Guide
Connect the power cable to the housing
6
100-240V AC power cable to AXIS T92A00
Warning!
High voltage - the electrical connection should be made by an authorized electrician.
Please observe relevant national and local regulations for the installation.
1. Using the small flathead screw driver, loosen the
screws in the Power in connector on the
connector board (fig.6).
2. Insert the (L-) (N+) and GND wires in the
connector and tighten the screws to secure the
wires.
3. Do not apply power until the installation is
complete and all wires and cables have been
connected.
4. Proceed to "Complete the installation" on page 9.
Complete the installation
7
1. Check that all cables and wires in the housing are properly connected.
2. Connect the AC mains power cable and check that the LEDs on the camera light up according
to the description in the Installation Guide.
3. Follow the instructions in the Installation Guide to install the camera on the network.
4. Once the installation is complete and the camera focus has been set, close the lid and tighten
the screws to lock the housing using the supplied hexagonal key.
5. The installation is now complete.
Note:
The Axis network camera installation guide is shipped with the camera or available from the Axis
web site at www.axis.com
All manuals and user guides at all-guides.com
Power in (100-240V AC)
FIG.6
Heater connector
Page 9
GND L- N+