HOMCOM EF821KUB Guide D'installation page 6

Instructions for Use
The appliance can be operated either by the switches located on the top right hand side of the
fire or by the supplied remote control.
Manual Operation
This is done by operating the switches located at the top right hand side of the fire .The standby
rocker switch must first be switched on, the fire will beep to indicate that it is powered up.
Press the O/I button once to turn on the appliance and fire effect. A red indicator light will show
to indicate that the fire is ON. Press the O/I button for 3 seconds this will operate the colour
flame mode, hold the button down until the desired colour flame is obtained, and there will be 7
colour available.
820-180(EF851KU): Press the 750W button once for the low heat setting; press twice to switch
off the heat setting. Press the 1500W button once for the high heat setting; press twice to switch
off the heat setting.
820-177(EF821KUB): Press the POWER button once for the low heat setting 750W; press
twice for the high heat setting 1500W; press three to switch off the heat setting.
Remote Operation
The standby rocker switch located at the top right hand side of the fire must first be switched on;
the fire will beep to indicate that it is powered up.
It takes a little time for the receiver to respond to the transmitter. Do not press the buttons more
than once within two seconds for the fire to operate normally.
820-180(EF851KU):
1) Connect the power
2) Turn on the power switch
3) Press the "ON/OFF" key of the remote controller to start up
4) Press the 750W button for the 750W heat settings; press twice to switch off the heat setting.
5) Press the 1500W button for the 1500W heat settings; press twice to switch off the heat
setting.
6) Press the COLOUR button for operate the colour mode, 7 colour available.
820-177(EF821KUB):
1) Connect the power
2) Turn on the power switch
3) Press the "ON/OFF" key of the remote controller to start up
4) Press the 750W/1500W button once for the low heat setting 750W; press twice for the high
heat setting 1500W; press three to switch off the heat setting.
5) Press the BACK LIGHT button to adjust the colors of LED decoration, 7 colors available.
6) Press the COLOUR button for operate the colour mode, 7 colour available.
Safety Cut-Off
This appliance is fitted with a safety cut-off which will operate if the fire overheats (e.g. due to
blocked air vents). For safety reasons, the fire will NOT automatically reset.
To reset the appliance, disconnect the appliance from the mains supply for at least 15 minutes.
Reconnect to the mains supply and switch on the appliance.
6