Publicité
Les langues disponibles
Les langues disponibles
Helpful Advice Before Fitting
Please retain all packaging until you have checked and counted all the parts and the contents of
the fixing pack against the parts list.
The fixing pack contains small items, which should be kept away from young children.
We suggest that you open the fixing pack and place all the contents into a container, therefore
reducing the risk of losing any small pieces.
Installation
Do not connect the heater until properly fixed to the wall and the instructions is read fully.
The minimum distances must be observed.
For installation of the heater, care must be taken not to damage concealed cables.
Please be careful while drilling the holes.
This appliance is designed to be permanently fixed to a wall at a minimum height of 300mm.The
wall bracket must be fitted horizontally and the cable routed to the bottom right of the heater.
A height of 600mm from bottom of heater to floor is recommended for optimum viewing of fuel
bed (see Fig.2 for recommend fixing dimensions).
Keep top of heater at least 1000mm away from ceiling or other objects for optimum heat
ventilation.
For optimum viewing, mark the top five screws fixing positions on wall in accordance with the
recommend fixing dimensions- see Fig.2. Drill holes with a six drill bit.
Fix the wall bracket using that the plug and screws provided .
Carefully lift the heater up ensuring that the two top rear slots of heater engages the wall
bracket (see Fig.3 ) and is sitting centrally.
Gently bring the heater level with the wall.
Mark the two bottom holes position-see Fig.5, remove the heater ensuring that the bottom fixing
bracket is rotated up.
Drill and fit wall plug.
Refit the heater to the wall fixing bracket and rotate the bottom fixing bracket down again and
use the screw provided to permanently fix the heater in place.
Unpack the pebbles from the bag and place them along the light unit in the desired position.
Place the front glass panel over the front of the heater aligning the hooks at each side of the
glass panel with the slots at each side of the heater body-See Fig.4. Then slide down the glass
panel in place. Again two people will be required for this operation.
Insert and tighten the front glass panel screw-See Fig.6 to secure the front glass panel to the
heater.
4
Publicité
