Emerson InSinkErator involve Serie Manuel Du Propriétaire page 3

cOMPOnents In thIs PacKage
HC-View-SS
Extension & Star Nut*
Washers
1-1/4"
HC-Wave-SS
Rubber* Small Steel*
H-View-SS
Extension & Star Nut*
Washers
1-1/4"
H-Wave-SS
Rubber* Small Steel*
Semi-Circular
H990-SS
Mounting Plate*
H770-SS Fiber Gasket* Mounting Plate
*component parts pre-installed on dispenser
4
3/8" Tube
Brass Nut / Ferrule /
3/4" Screws (2) Quick Connector
1-5/16" 1-1/2"
1-1/4"
Large Steel Fiber
3/4" Screws (2)
1-5/16"
1-1/2"
1-1/4"
Large Steel Fiber
Wing Nut* Rubber Gasket* 3/4" Screws (2)
Metal
Mounting Screw* 3/4" Screws (2)
START HERE
1
PRePaRatIOn
a
Required minimum
from center of hole
HC-View-SS ..... 2-5⁄8" .................... 3"
Tube Insert H-View-SS ....... 2-5⁄8" .................... 3"
HC-Wave-SS .... 2-5⁄8" .................... 3"
H-Wave-SS ...... 2-3⁄8" .................... 3"
H990-SS .......... 1-1⁄4" .................... 3"
H770-SS .......... 2" ........................... 3⁄4"
Tank
The wall outlet for your dispenser must have power supplied to it continuously
and must be fused. It should not be controlled by the same wall switch
that operates your disposer, unless using an InSinkErator SinkTop Switch
b
Tank
If you have to drill through sink or
countertop, you may need to rent or
purchase the appropriate tools.
C
Tank
Consult a professional before drilling into
Tank
a surface other than stainless steel.
Identify locations for the dispenser
Maximum counter
faucet, tank and filter (if applicable).
thickness (depth)
to wall
check to make sure there is proper
clearance (see chart at left) for
dispenser handles to be fully opened.
check to make sure counter is not
too thick (see chart at left).
Make sure there is a grounded
electrical outlet under the sink.
turn off water supply.
If using the sink sprayer hose hole,
remove nut that connects sprayer
hose at bottom of faucet.
Using adjustable wrench, remove
nut connecting sprayer washer
flange in sprayer hole.
Plug hose opening with either a 1/8"
plug or a 1/4" cap (not supplied).
What if you don't have a sprayer hole
or don't want to use it?
Required Hole Size Many homeowners replace the
soap dispenser in their sink with an
1-1⁄4" – 1-1⁄2"
instant hot water dispenser.
Dependent on model
If drilling a hole into a stainless steel
sink or counter top, you can cut a
mounting hole for the dispenser with
a hole saw for stainless steel, or you
can use a hole punch.
.
™
5