Cable Routing For Nursing Home Beds - wissner-bosserhoff SafeSense Notice D'utilisation

6.5 Cable routing for nursing home beds

When installing SafeSense
damaged in any way. For this reason, the steps below are to be followed to ensure proper
cable routing:
1. Cable routing for beds with cable opening on the side:
Use a cable clip to attach the nurse call cable to the power cable.
Always run the nurse call cable along the power cable to the head end of the bed and attach
it to the power cable using a cable clip.
2. Cable routing for beds with cable opening at the head end:
Run the nurse call cable from the Bed-Exit Box into the cable conduit, which also contains
the power cable. Use a cable clip to attach it to both the inside of the head end and the cable
relief at the head end.
3. Cable routing for beds with a D-Box on the frame:
42
Secure the Bed-Exit Box to the battery using the two
screws supplied.
Clip the battery into the holder on the bed.
The remaining installation steps are identical to
those for beds with no battery.
please take care to ensure that the cables are not pinched or
®
Guide the nurse call cable to the D-box and insert it
into the cable conduit.